BLUEFIN Fitness TOUR Lite Manual De Instrucciones página 13

D I S P L A Y V A L U E S
SPEED
TIME
DISTANCE
CALORIES
PULSE
AUTO ON
AUTO OFF
SCAN
This function shows the current training speed.
To display the current speed, press the MODE button until the function speed flashes and is shown
on the display. If no signal is sent to the product during your workout, the display will show a SPEED
value of "0.0"
This function automatically measures the training time as soon as you start training.
To display the current workout duration, press the MODE button until the function time flashes and is
shown on the display. If you do not preset a specific value, the time will be counted like a traditional
stopwatch. If you use the SET button to preset a specific target value, time is counted down until the
value "0:00" is reached.
This function shows the distance you have covered during the workout so far.
To display the distance you have covered so far, press the MODE button until the function Distance
flashes and is shown on the display. If you do not preset a specific distance the display will show the
distance you have covered during your workout. If you use the SET button to preset a specific target
value, time is counted down until the value "0:00" is reached.
This function shows the calories you have burned so far.
To display the calories you have burned so far, press the MODE button until the finction Calories
flashes and is shown on the display. If you do not preset a value, the display will show the
approximate amount of calories you have burned durning your workout. If you use the SET button to
preset a target value, the set value is counted down until the value "0.00" is reached.
This function automatically records and displays your respective heart rate during the workout.
To display the currnt heart rate, press the MODE button until the function Pulse flashes and is shown
on the display. To measure your pulse, use both hands to grasp the handlebars at the point of the
heart-rate contact sensors.
Notice: The pulse monitor is a workout aid, not a medical device.
WARNING: The heart-rate monitoring system my be faulty. Working out too often or too intensively
can lead to dangerous injuries or death. If you experience an unusual severe reduction in
performance, stop training immediately. If you do not preset a value, the current heart rate in beats
per minute is shown on the display. Use the SET button to set a target heart rate. Once the target is
exceeded you should reduce the speed or selected resistance until your heart rate drops below the
target value. If no pulse signal is sent to the product durning your workout, the display will show a
PULSE value of "P"
To start the display, press the MODE button or start pedaling.
The display will turn off automatically if you do not press any buttons or turn the pedals for four
minutes.
This mode automatically cycles through all the functions. In this mode, the individual values appear
one after another on the display. To display all functions on the display in sequence, press the MODE
button until the Scan function appears in the upper left corner of the display. The current values of
the functions Speed, Time, Distance, Calories and Pulse are shown on the display in sequence for
about five seconds each.
//
E N
//
T O U R L I T E 1 3