Publicidad
Idiomas disponibles
Idiomas disponibles
Make sure the pressure washer
is off for the following steps.
2. Attach the surface cleaner to the high
pressure 1/4" quick connect on the
pressure washer spray wand.
3. Pull back the quick connect collar on
the spray wand
4. Push the surface cleaner connector
into the pressure washer spray wand
quick connect.
5. Push the collar forward until it clicks
into place.
6. Check that the surface cleaner is
connected by pulling the surface
cleaner forward.
7. Connect the wand to the spray gun in
accordance with the pressure
washer's instruction manual.
8. Start the pressure washer and begin
cleaning.
Proper Use
●
This surface cleaner can be used on
various materials including concrete,
stone, tile, plastic and more.
●
This surface cleaner is designed for
use only on horizontal surfaces.
●
Be sure to test the cleaner in an
inconspicuous area.
●
Never operate in the same area for
more than two seconds as damage
may result.
●
Do not use on windows.
●
This surface cleaner has not been
designed for use in commercial
applications.
●
Do not run over freestanding corners
as damage may result
Troubleshooting / Maintenance:
A clogged or dirty nozzle will result in
excessive pump pressure causing a
pulsing sensation.
1. Turn off the pressure washer and
unplug the cord.
2. Shut off the water supply.
3. Release any residual pressure in the
system by squeezing the gun's
trigger.
4. Disconnect the Surface Cleaner from
the pressure washer wand.
5. Using a flat screwdriver, pry the
retaining clip from the spray bar.
Remove the nozzle by wiggling it and
pulling straight up.
6. Using a needle, free any foreign
material clogging the nozzle.
7. Use a garden hose to flush the
nozzle by spraying water through the
nozzle.
English 19
Publicidad
