Motorola PMPN4350 Guia Del Usuario página 15

Status
Fault
Standby
End of Service Life
Calibration
Calibration Required
3.2
Initialization
The data in Motorola Solutions IMPRES batteries must be initialized by the charger the first time it is
charged to ensure the features of Motorola Solutions IMPRES batteries and the Adaptive Charging
System to be fully available.
This battery initialization is indicated by a Steady Amber light on the charger indicator. The process
is automatic, includes an initial calibration of the battery, and begins charging upon completion of this
process. This process requires time to initialize the battery. The battery should be left in the charger for
approximately 12 hours or more to complete the process. Do not remove the battery from the charger
until the Steady Green light is on.
LED Indicator
Blinking Red
Blinking Amber
Alternating Red/Green
Steady Amber
Alternating Amber/Green-Ini-
tial Charge
Alternating Amber/Green-End
of Charge
MN004263A01-AK
Chapter 3 : Charging Procedure
Description
Refer to Troubleshooting on
page 18.
Battery is waiting to rapid
charge. Battery may be too
hot, too cold, or low voltage
Battery continues to be usable
but may be nearing the end of
its rated service life
Battery is in calibration mode
Battery requires calibration
but calibration is disabled in
charger.
NOTE: The battery
continues to charge
normally (blinking
green) if it is not re-
moved after 5 sec-
onds.
Battery requires calibration
but Calibration is disabled in
charger.
NOTE: Instead of
steady green, the
indicator alternates
amber and green to
indicate that the bat-
tery is fully charged.
15