Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
The lever handle controls the flow of hot and cold water to the faucet. Rotate the handle out and
forward for cold water. Rotate the handle out and backward for hot water. Moving the handle
outward opens the cartridge and causes water to flow from the spout. The degree of handle opening
determines the volume of water flow. Returning the handle to the original position toward the faucet
body stops the flow of water.
CARE AND CLEANING
Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these
will dull the finish and void your warranty.
TROUBLESHOOTING
If a faucet installation doesn't deliver water properly or leaks, finding the cause and fixing it can be easy.
PROBLEM
POSSIBLE CAUSE
Faucet leaks
Bonnet has come loose or
underneath
the ceramic cartridge seal
handle.
is dirty or out of place.
Water does not
Ceramic cartridge discs
completely shut
are worn or have debris
off.
trapped inside.
Faucet leaks
The aerator is incorrectly
around aerator.
fitted, dirty, or small parts
inside the aerator are
improperly installed.
Faucet has an
The aerator is dirty or
improper water
small parts inside the
pattern.
aerator are improperly
installed.
The connector is blocked. 1. Remove the spray head by unscrewing it from the hose assembly.
No water pressure
or low water
pressure after a
longer period of
use.
SOLUTION
1. Move the handle to the OFF position. Unscrew the handle screw and
remove the handle.
2. Tighten the bonnet by turning it clockwise. Move the cartridge stem to the
ON position. The leak should stop draining out from around the cartridge
stem.
3. If the leak does not stop, shut off the water supply. Remove the bonnet
by turning it counterclockwise. Lift out the ceramic cartridge. Inspect the
seal on the bottom of the ceramic cartridge. Remove any debris from the
seal. If the ceramic cartridge seal is twisted or out of place, re-seat it. If
the ceramic cartridge seal is worn or damaged, replace the cartridge by
calling customer service.
4. Position the cartridge back into the faucet body. Tightly screw the bonnet
onto the faucet body.
5. Reinstall the handle.
1. Shut off the water supply.
2. Move the handle to the OFF position. Unscrew the handle screw and
remove the handle.
3. Remove the bonnet. Lift out the ceramic cartridge.
4. Position the new ceramic cartridge into the faucet body.
5. Tightly screw the bonnet into the faucet body.
6. Reinstall the handle.
1. Remove the aerator from the spray head on the faucet body. Inspect the
black rubber gasket inside the aerator. The rubber gasket should be flat.
2. Reinstall the aerator on the spray head.
1. Remove the aerator from the spray head on the faucet body.
2. Gently flush the small parts inside the aerator to clear away any debris.
3. Reinstall the aerator on the spray head.
2. Hold the end of the hose assembly down into the sink and turn the faucet
on to the warm position where it mixes the hot and cold water. If the water
flow is still slow or completely blocked, please call customer service.
6
Publicidad
