Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
•Machine does not cool:
•Check that the power plug is properly
inserted and the appliance has electrical
energy.
•The safety device of the compressor
comes into action: wait 5-10 minutes
before restarting the machine. Rapid and
continued start-up attempts do nothing but
prolong the period of inactivity of the
machine.
•Check that the machine is correctly
positioned with the ventilation grids (6) free
of any obstructions.
•Check that the machine is not running a
preservation cycle (LED (11a,b,c,d)
flashing) that stops the compressor.
•Check that when the machine (switch (10))
turns on, the control panel shows the
correct initialization procedure by turning
on all LEDs in sequence.
•The paddle does not turn:
•Check that the paddle (5) is properly
attached to the tube and locked with a
special locking ring (4).
•Make sure it is free from obstacles that
prevent it from rotating.
•Make sure the lid is closed in the correct
position: a safety device stops the paddle
when the lid is opened.
•Check that the LED paddle (2a) is not
flashing. In this case, press the button (2)
twice to restart the paddle. Make sure that
the mixture is not too thick to prevent the
BLADE ACTIVATION
COMPRESSOR ACTIVATION
PROGRAM ACTIVATION
PRESERVATION ACTIVATION
TURN OFF FROM PROGRAM
TURN OFF FROM CONSERVATION
PROGRAM CHANGE
CONSERVATION CHANGE
PROGRAM ACTIVATION FROM CONSERVATION*
PROGRAM ACTIVATION FROM CONSERVATION***
* If conservation is activated after a program.
** To activate the program whose LED is flashing, first select a different program.
*** If conservation is activated without running programs.
English
ACTION
rotation of the paddle.
•Make sure that the machine is not running
a preservation cycle (LEDs (11a-b-c-d)
flashing) that stops the paddle.
•The machine is noisy:
•Some noise is part of the normal operating
specifications, but if it becomes excessive
contact the Service Centre to avoid further
and more serious problems.
•The water discharge pipe leaks:
•Replace the gaskets of the water
discharge tap (9). Two additional gaskets
sets (16) are provided with the machine.
Lubricate the gaskets before fit the tap (9)
into the water discharge tube.
•The plastic sleeve (17) on the lower part of
the paddle is tto easy to separate.
•Replace the gasket with the new one. Four
additional gasket (15) are provided with
the machine.
•The paddle does not scrape properly the
sides of the bowl.
•Check that the scrapers (18), (19) and (21)
are not damaged or worn.
•Check that the resilient pads (20) are not
distorted. If they are distorted replace them
with new parts. One set is included.
KEY COMBINATION
2
1
11
1+2 (3 seconds)
11 (3 seconds) then 1 and 2
11 (3 seconds)
11
12
11**
11
15
Publicidad
