Publicidad
Idiomas disponibles
Idiomas disponibles
SELECTED PROGRAM VARIATION
Should it become necessary to select a
different program when a program is running,
you can simply press button (11). When the
new program is selected, the currently
running program will stop. The new program
will be active immediately with its own
execution times that will restart from the initial
values.
S W I TC H I N G F R O M AU T O M AT I C T O
MANUAL OPERATION
During the processing program, it is possible
to switch to manual mode at any time.
Holding down button (11) for 3 seconds
switches the machine to manual mode while
enabling the paddle LEDs (2a) and
compressor (1a).
The preservation cycle selected will be
deactivated.
TURNING OFF THE MACHINE DURING
AUTOMATIC OPERATION MODE
If you need to turn off the machine before the
completion of the active processing program,
you first need to switch to manual mode by
pressing and holding button (11) for 3
seconds and then pressing paddle (2) and
compressor (1) to stop any activity. Do not
act directly on the main switch (10)!
PRESERVATION CYCLE VARIATION WHILE
A PROGRAM IS RUNNING
During the preparation phase it is possible to
automatically vary the preservation cycle set
at any time. Repeatedly press button (12) until
the LED that corresponds to the desired cycle
is activated. The LED will flash for 3 seconds
a n d b e c o m e s s t e a d i l y l i t : t h e n e w
preservation cycle is selected at this point
and will be performed at the end of the
program. Each preparation program will
a c t i v a t e a t t h e e n d o f t h e s e l e c t e d
preservation cycle.
PADDLE LOCK UPON LID OPENING
The opening of the lid (3) only stops paddle
(5) and does not affect the preparation
program.
The closure of the lid (3) starts the motion of
the paddle (5) (where, at that time it is
provided by the selected program). If the
English
mixture proves excessively thick to prevent
the movement of the paddle, the machine will
automatically activate the previously selected
preservation cycle.
PADDLE SPEED ADJUSTMENT
The paddle rotation speed is adjustable by
means of the knob (8).
The adjustment of the paddle speed is
completely independent from the execution
of programs and can be changed at any time.
Air intake into the mixture varies according to
the recipe and paddle rotation speed.
To a lower number of revolutions corresponds
a higher density. (less air incorporated into the
ice cream). To a greater number of revolutions
corresponds a smaller density of the product
(more air incorporated into the ice cream)
We recommend you use low speeds when
preparing classic Italian gelato, Granita and
sorbet, and high speeds when preparing
semi-soft Italian gelato.
AUTOMATIC PRESERVATION
There are 4 preservation cycles available for
every whipping program (total of 16 cycles)
devised to meet a wide range of needs.
•In automatic mode, if the machine is not
stopped, at the end of each production
cycle is enabled the ice cream preservation
cycle selected.
•The activation of the preservation function is
i n d i c a t e d b y f l a s h i n g o f t h e L E D
corresponding to the processing program
of the ice cream selected.
•The desired cycle selection can take place
either at the beginning or during the
processing phase.
•Depending on the type of recipe and/or the
quantity prepared, every set of preservation
cycles combined with paddle speed
enables keeping gelato, Granita and sorbet
or other whipped products at the desired
conditions.
•Pressing the button (12) several times
causes the selection LEDs of the various
preservation cycles to light up in sequence.
If you switch from the first (LED (12a) active)
to the fourth (LED (12d) active) preservation
program, the density of gelato increases
9
Publicidad
