Pit Boss ULTIMATE GRIDDLE Serie Guía De Montaje página 6

3. SECURING THE DRAWER RAILS
Parts Required:
1 x Drawer Rails (#18)
5 x Screw (#A)
Installation:
• Align the holes of the Drawer Rails to the holes on the left side of the
Cart Bottom, then secure using five screws, as shown.
4. MOUNTING THE DRAWER SUPPORT BAR
Parts Required:
1 x Drawer Support Bar (#19)
2 x Screw (#A)
Installation:
• Insert the tab of the Drawer Support into the Cart Partition, then secure
the Drawer Support using two screws, one on each side.
5. INSTALLING THE HEAT SHIELD
Parts Required:
1 x Heat Shield (#20)
6 x Screw (#E)
Installation:
• Place the Heat Shield into the body of the Cart with the brackets on the
left side, as shown in illustration. Align the mounting holes and secure
using six screws.
IMPORTANT: The upward edge of the Heat Shield should be facing
the front of the unit.
6
3
A
18
4
A
5
E
20
19
E