Teac IW-C5i Manual Del Usuario página 12

If the pairing process fails, the PAIRING button on the TX-C5i begin to
flash in red slowly. In this case press both PARING buttons simultaneously
to start the process again.
< The STANBY/ON button on the RX-C10i flashes slowly when the pairing
process is successful.
If the process fails, the RX-C10i turns to ready mode. In this mode the
STANDBY/ON button on the RX-C10i flashes faster.
3
Turn on your amplifier or other audio equipment that was
connected to the LINE OUT terminal, and select this unit as a
source.
4
Turn on the iPod nano, and playback from the iPod's music list.
Then gradually turn up the volume of your amplifier to the
required level.
To turn off the unit
Press and hold the STANDBY/ON switch for more than three seconds. The
button lights will turn off.
< Don't forget to turn off the iPod nano.
12
Listening to iPod nano 2