Be Cool easy Manual De Instrucciones página 23

EN
2_ Tighten the top tether until the top tether regulator
shows green, and shake the seat to check whether
the top tether is tightened.If you want to release the
top tether, press the regulator button and pull the top
tether in the opposite direction, then you can relax the
top tether and take out the top tether hook.
3_Only suitable for children with height less than or
equal to 60cm
5 I-SIZE (40-105cm) Child mounting
method (backward)
1_ Press and hold the central regulator button while
pulling the shoulder strap outwards to relax the shoul-
der strap.
2_ Press the red button to open the buckle.
3_ Pull out the shoulder straps and place them on both
sides of the seat.
4_ When i-size (40-105cm) is used by children, please
refer to the above picture description for
44
the shoulder strap.
5_ Pull and adjust the safety belt outward to make
the shoulder belt effectively restrain the children, and
reserve a certain space to prevent the child seat belt
from pressing the children too much. The adult palm
can be inserted just between the safety belt and the
children's chest. It is better not to be loose or tight, and
ensure that the pelvis area can be well restrained
when the belt is worn.Note: The bottom of both sides
of the shoulder shield should be close to the same
level and pulled down to the bottom.
6_ How to use the buckle: put the buckle insert around
and together, and then insert the buckle slot at the
same time. The sound of clicking indicates that the
buckle has been stuck.Then pull up the clip insert to
check whether the clip is properly locked.To unfasten
the clasp, press the red button and the clasp insert will
pop out automatically.
7_ Pull the headrest handle upward to adjust the height
of the headrest. Adjust the height to the right position
according to the different heights of the child.
8_ After the baby is seated, adjust the head to the right
position (note: the lowest part of the head is 1-2 fingers
away from the shoulder is the best).
6. I-SIZE UNIVERSAL (76-105cm):
ISOFIX+Top tether+ five-point safety
belt
Attention
A_ Suitable for models with ISOFIX systems which
pass ECE R14 .
B- The I-size seat is installed forward, suitable for 76-
105cm children. It has 4 adjustable sitting positions,
2/3/4/5 gear respectively.
C- I-size seats cannot be installed in places with
airbags.
D_ "IMPORTANT-DO NOT USE FORWARD FACING BE-
FORE THE CHILD'S AGEEXCEEDS 15 months(Refer
to instructions)"
E_ Important - The seat should not be used laterally
in the driving condition.
I-size (76-105cm)ISOFIX installation — When used
forward, remove the backward protection system.
1_ Please rotate the seat to the forward state with 4
adjustable gears.
2_ Press the ISOFIX button at the bottom of the seat
forward and backward with your hand, push the ISOFIX
on both sides to the maximum, press the end of the
ISOFIX, and it will not be retracted.
3_ Insert the ISOFIX of the baby car seat into the
corresponding ISOFIX fixed point of the car, and a click
will be heard to display green in the display window.
It will display red in the window before ISOFIX inserted
correctly.
4_ As shown in the figure, before installing the ISOFIX
please take out the top tether kit in the back cover,
pullout the top tether of a certain length, and hang it on
the head temporarily.
5_ Push the baby car seat to the back of the car seat to
make them fit tightly. Shake the seat from side to side
to make sure it is effectively fixed.
7. I-SIZE (76-105cm) top tether installation
EN
45