Publicidad
Idiomas disponibles
Idiomas disponibles
Before first use / First use
Before first use
Q
DANGER OF INJURY!
Switch the device off and pull the plug out of the
mains socket before carrying out any work on the
device.
Attaching the auxiliary handle
Q
NOTE: For safety reasons this tool must always be
used with the auxiliary handle
T urn the wing screw
the additional handle
T hen tighten the wing screw
Using the depth stop
Q
O pen the wing screw
M ake sure that the toothing on the depth stop
is pointing downwards.
P ull the depth stop
so that the distance between the tip of the drill
and the tip of the depth stop corresponds to
the desired drilling depth.
F irmly tighten the wing screw
Inserting tools
Q
Quick-action drill chuck:
T ake firm hold of the back casing
quick-action drill chuck
casing
until the tool can be inserted.
2
I nsert the tool.
T ake firm hold of the back casing
quick-action drill chuck
casing
firmly shut.
2
Assembly tools for screws and nuts:
W hen using screwdriver bits, always use a
universal bit holder.
T o screw things in, always switch the changeover
switch "drill / percussion drill"
position .
36 GB/MT
in place.
10
anti-clockwise and swivel
9
into the desired position.
10
again.
9
.
9
out as far as necessary
8
.
9
of the
3
and turn the front
1
of the
3
and turn the front
1
to the right to
4
First use
Q
Switching on and off
Q
When operating the hammer-action drill you can
select between intermittent or continuous operation
mode. In either mode the device functions as follows:
To switch on intermittent operation mode:
P ress the ON / OFF switch
To switch off intermittent operation mode:
R elease the ON / OFF switch
Switching continuous operation on:
P ress and hold the ON / OFF switch
and press the locking button
To switch off continuous operation mode:
P ress and then release the ON / OFF switch
8
Infinitely adjustable
Q
speed setting
The ON / OFF switch
P ressing the ON / OFF switch
speed.
Setting the direction of rotation
Q
W ith the rotational direction switch
change the rotational direction of the electrical
tool.
NOTE: This is, however, not possible when the
ON / OFF switch
NOTE: Hold the appliance in the direction of work.
Clockwise rotation:
P ush the rotational direction switch
Left in order to drill and to screw in screws.
Anticlockwise rotation:
P ush the direction of rotation switch
right to slacken a screw or screw it out.
.
6
.
6
down
6
.
5
has a variable speed control.
6
increases the
6
you can
7
is pressed down.
6
to the
7
to the
7
.
6
Publicidad
