Publicidad
Idiomas disponibles
Idiomas disponibles
LIQUID PROPANE CYLINDER REQUIREMENTS (20-lb Cylinder):
A self-contained LP-gas cylinder for use with this appliance must have a capacity of 20 lbs.
•
and must be equipped with a Type 1 connector and an OPD (overfill protection device).
The LP-gas supply cylinder to be used must be constructed and marked in accordance with
•
the specification for LP-gas cylinders of the U.S. Department of Transportation (DOT) or the
National Standard of Canada, CAN/CSA-B339, Cylinder, Sphere and Tubes for the
Transportation of Dangerous Goods.
•
The cylinder supply system must be arranged for vapor withdrawal.
•
The cylinder used must include a collar to protect the cylinder valve.
•
This appliance should be used only outdoors in a well-ventilated space and shall not be used
in a building, garage or any other enclosed space.
•
When this appliance is not is use, the gas must be turned off at the supply cylinder.
•
Storage of this appliance indoors is permissible only if the cylinder is disconnected from the
appliance.
•
Cylinders must be stored outdoors in a well-ventilated area out of the reach of children.
Disconnected cylinders must have threaded valve plugs tightly installed and must not be
stored in a building, garage or any other enclosed areas.
The LP gas cylinder (not included) is threaded for the connection directly to the gas regulator
supplied with this appliance. Care should be taken when threading the regualtor to the cylinder.
Engage to threads correctly to achieve the proper and intended connection. When disconnecting
or connecting the gas cylinder, be careful that the regulator does not strike the appliance, the
ground, or any other surfaces. If any difficulty occurs when connecting or disconnecting the
regulator assembly to the cylinder, contact your local gas supplier for assistance.
When re-connecting the regulator to the LP gas cylinder, be sure to fully tighten the connection.
This connection should be inspected for damage and a leak test should be performed after each
re-connection.
The minimum distance between pizza oven and gas cylinder is 36 inches.
6
Publicidad
