Publicidad
Idiomas disponibles
Idiomas disponibles
ADDED FEATURE
Your appliance is equipped with an adjustable low-pressure regulator. The normal
operating pressure is 11" water column and the lower operating pressure available
is 9.5" water column. When operating your appliance under normal circumstances
you will want to have the regulator set at the 11" water column pressure. If you want
to cook with slightly lower temperatures, then set the regulator to the 9.5" water
column setting. Depending on what temperature setting you have the control knob
set at will determine how much lower your temperatures will be when using the
lower pressure setting. Please see the instructions on how to change from the 11"
water column setting and back again.
HOW TO SET REGULATOR SETTING
• Pull back the spring-loaded coupling to release regulator cap to achieve 9.5"
water column.
• Pull back the spring-loaded coupling then push the regulator cap firmly and
release. The regulator cap will snap in and lock in place to reset the regulator to
11" water column.
LEAK TEST PROCEDURE
1. Attach hose assembly to the cylinder.
2. Slowly open the cylinder valve.
3. Perform a leak check on regulator to griddle hose to regulator and hose to cylinder
connections with soapy water. Bubbles indicate a leak. Check that the connection
is not cross threaded and that it is tight.
4. Perform another leak check. Check the coupling nut for tightness. If there is still a
leak, remove the cylinder and contact the manufacturer for service and repair.
5. When appliance is not in use, turn off the control knob and LP tank valve on the supply cylinder.
6. Never use an LP tank if visibly rusted, damaged, or out of date.
7. If you notice grease or other hot material dripping from appliance onto the valve, hose or regulator, turn off gas supply at
once. Determine the cause, correct, clean and inspect valve, hose and regulator before continuing. Perform a leak test.
8. The regulator may make a humming or whistling noise during operation. This will not affect the safety or use of appliance.
9. Clean and inspect the hose before each use of the appliance. If there is evidence of abrasion, wear, cuts or leaks, the hose
must be replaced prior to the appliance being put into operation. See product tag for hose and regulator information.
18
10. Do not block holes in bottom or sides of appliance.
11" Water Column
Leak Check
9.5" Water Column
8.5" Water Column
11" Water Column
11" Water Column
Publicidad
