Bahco BBT60A Instrucciones Originales página 8

BBT60A
3. Press the / key to select the battery type:
4. Press «ENTER» to confirm choice.
5. Press the / key to select the battery rating:
CCA/SAE, EN, JIS, DIN, IEC, & CA/MCA.
6. Press «ENTER» to confirm choice.
7. Press the / key to input the battery capacity.
CCA/SAE: 40~2000
EN: 40~1885
DIN: 25~1120
IEC: 30~1320
JIS: By Battery Type No.
CA/MCA: 50~2400
8. Press the / key to confirm temperature.
9. Press <<Enter>> to begin the test.
*Return Feature:
Before the test is started, the user can always return to the previous setting page by pressing
<<ENTER>> for 2 seconds.
SURFACE CHARGE NOTICE
The battery will hold a surface charge if the engine has been running or after the battery has been charged. The
tester may prompt you to remove the surface charge.
A. Follow the instructions indicating when to turn the headlights on and off or apply a load into the battery.
IN VEHICLE:
SURFACE CHARGE
IN VEHICLE? YES
OUT OF VEHICLE:
SURFACE CHARGE
IN VEHICLE? NO
B. The tester will resume testing after it detects that the surface charge
is removed.
TURN HEADLIGHTS
ON FOR 15 SECS
TESTING
EN
BATTERY TYPE:
AGM FLAT PLATE
SELECT RATING:
CCA/SAE
SELECT CAPACITY:
560CCA/SAE
ABOVE 32°F/0°C?
YES/NO
TESTING