Publicidad
Idiomas disponibles
Idiomas disponibles
12V BATTERY TESTER
10. Test the battery for few seconds.
11. Press the
/
key to select battery fully charged or not if
tester asks. Press «ENTER» to confirm choice.
12. When the test is completed, the display shows the actual volts and the actual CCA and internal
resistance. {Press the
SOH (STATE OF HEALTH) and SOC (STATE OF CHARGE)}.
13. One of the six test results will be displayed:
GOOD & PASS
*The battery is good and capable of holding a charge.
GOOD & RECHARGE
*The battery is good but needs to be recharged.
CAUTION
*The battery may be serviced but decrease the capability of starting
the engine gradually. The battery may fail under extreme climate
conditions. There may be a poor connection between the vehicle and
the battery affect the charging function. Please pay attention to the
battery for replacement consideration and charging system checking.
RECHARGE & RETEST
*Battery is discharged, the battery condition cannot be determined until
it is fully charged. Recharge & retest the battery.
BAD & REPLACE
*The battery will not hold a charge. It should be replaced immediately.
/
key to read:
EN
IS BATTERY
CHARGED? YES/NO
GOOD & PASS
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
GOOD & RECHARGE
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
CAUTION
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
RECHARGE & RETEST
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
BAD & REPLACE
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
9
Publicidad
