PRACTICAL GUIDE FOR THE
OPERATOR
Clothing and equipment
Wear safety shoes with non-slip soles.
Wear protective goggles or visor and safety garments.
Depending on the surface being cleaned and on the
environment, the protective measures necessary for
atomized sprays include respiratory masks with class
FFP2 or equivalent or higher protection.
Before starting the machine
Clear away larger items of refuse before washing. Pick up
any pieces of wire, tape, string and similar items that could
become entangled around the brushes.
Before washing is commenced, sweep the area so as to
Preparing the machine for work
Proceed as follows before starting work.
-
Check that the batteries are fully charged, and
if not, carry out the recharging procedure: when
undertaking this operation, refer to the section
"Charging the batteries".
-
Make certain that the dirty water tank is empty, and
if not, empty it, referring to the section "Emptying
the dirty water tank".
-
Make certain that the solution tank is full, and
"Filling the water/detergent tank".
-
Working
reading the operating and maintenance manual.
! NOTICE
Releasing the accelerator pedal, all of the functions
are stopped automatically within 5 seconds (Power
corresponding to the selected program will blink. To
reactivate the functions, simply move the machine
On).
! NOTICE
Whenever the machine moves in reverse, the
squeegee is raised automatically to prevent any
possible damage.
! DANGER: Never use the machine to clean up
oil, etc.), acids or solvents (e.g. paint thinners,
acetone etc.) even if diluted.
-
Sit on the seat.
-
Turn the ignition key to switch the machine on.
EN
22