Picking up water (without scrubbing)
The machine can be used to mop up spills of water or
Press the suction motor button: the squeegee is lowered
and the suction fan comes into operation.
Proceed to pick up the liquids.
During operation of the machine
-
Keep the cleaning passes as straight as possible.
-
Overlap successive cleaning passes by a few
centimetres.
-
Adjust the ground speed of the machine, the
detergent to suit the type of cleaning. Use the
minimum available settings, as far as practically
possible, for the brush pressure and detergent
-
Check the battery charge indicator to ensure
cleaning operation.
-
Check the detergent solution level indicator to
ensure that the relative tank is not empty.
-
Check the dirty water level indicator to ensure that
the relative tank is not full.
-
Keep the machine moving forward to prevent
! ATTENTION: dthe scrubhead and squeegee will
automatically raise to the transport position if key
potential pinch hazard.
! ATTENTION: do not attempt to clean surfaces on
slopes or gradients steeper than indicated on the
machine data plate.
! ATTENTION: Do not operate the machine on slopes
or gradients steeper than indicated on the data plate.
! ATTENTION: When using the machine on gentle
gradients, do not move transversely across the
slope, but keep the machine on a line parallel to the
direction of the incline, manoeuvring carefully and
without making U-turns.
Emergency stop button
In the event of emergency, this button isolates the machine
from its power source.
To restart the machine, rotate the button and cycle the key.
EN
26