Replacing the squeegee blades
! ATTENTION: before carrying out the operations
apply the parking brake.
time, and the constant wiping action, the edge of the blade
blade is required.
-
Remove the suction hose from the squeegee.
-
Remove the squeegee from its mount by
unscrewing the two knobs completely.
-
Release the locking catch and unscrew the nuts
for the rear blade; for the front blade, unscrew the
nuts.
-
Remove the blade retainers.
-
Remove the blade.
-
that all four edges in turn are placed in contact
likewise for the front blade, in this case until the
two edges are worn out; alternatively, replace with
the squeegee.
-
-
the rear blade, and for the front blade, retighten
the nuts.
-
Replace the squeegee on its mount.
Cylindrical Brush Model side brushes wear
adjustment
! ATTENTION: before carrying out the operations
apply the parking brake.
due to excessive wear, they can be adjusted as follows:
-
Move the side brush to the working position.
-
Loosen the adjustment screws on the brush motor
support.
-
Position the brush by hand, as required.
-
Tighten the adjustment screws.
Machine Jacking
! ATTENTION: before carrying out the operations
apply the parking brake.
! DANGER: when lifting the machine, use
suitable equipment with a load capacity
! DANGER: the machine must be lifted only
from the points indicated below.
! DANGER: empty the dirty water and detergent
solution tanks before lifting the machine.
EN
34