Battery: removal
!
following precautions:
Contact with the skin can cause irritation; wash
with soap and water.
Inhalation of vapours can cause irritation to the
airways; stay out in the open air and consult
a doctor.
Contact with the eyes can cause irritation;
for at least 15 minutes, and consult a doctor.
! DANGER: When removing the batteries, the
skilled technician must wear the Personal
Protective Equipment (gloves, eyewear,
overalls, etc.) needed to limit the risk of
accidents; remove the ignition key from the
control panel before proceeding with the
removal operation, keep away from naked
do not cause sparks and do not smoke.
! ATTENTION: the operation of removing the batteries
must be carried out by a skilled technician.
! ATTENTION: before carrying out the operations
apply the parking brake.
-
Disconnect the battery cables and bridge terminals
from the battery poles.
-
to the base of the machine.
-
Lift the batteries from the compartment using
suitable handling equipment.
Replacement of Brushes and Pads
The machine can be equipped with disc brushes, roller
brushes and pads. Check the brushes and the pads every
day to make certain there are no wires, threads or strings
entangled around the brush or the drive board. Check for
wear on the brushes and the pads.
Replace the brushes when the bristles are worn down to
the point of exposing the red indicator.
Wash the brushes and pads with soap and water following
use, and hang them up to dry.
EN
33