Detergent solution tank empty indicator
When the solution tank is empty, the indicator lights up and
all cleaning functions are inhibited. The detergent solution
refer to the section "Filling the detergent solution tank".
Dirty water tank full indicator
When the dirty water tank is full, the indicator lights up and
all cleaning functions are inhibited. The dirty water tank
must now be emptied: when carrying out this operation,
refer to the section "Emptying the dirty water tank".
Battery charge indicator
The display indicates the battery voltage: when this
disabled, whereas traction remains enabled; proceed with
the recharge, follwing the instruction given in the section
"Recharging the batteries".
Emptying the dirty water tank
! ATTENTION: before carrying out the operations
apply the parking brake.
When cleaning operations have been completed, empty
the dirty water tank.
If the tank is full, the indicator lights up and the cleaning
functions of the machine will be inhibited; after a few
seconds, the suction motor also shuts down. At this point
the machine must be brought to a halt and the dirty water
tank emptied, following the instructions indicated
-
Take the machine to the designated service area.
-
Unhook the hose from the clip.
-
Empty the tank by way of the drain hose: keep
the hose raised initially and remove the plug, then
lower the hose gently and position it over the drain
outlet.
-
Rinse the tank with clean water.
-
the directions given in the section "Cleaning the
dirty water tank sensor".
-
hose to the clip.
EN
below:
27