Publicidad
Idiomas disponibles
Idiomas disponibles
•
Then connect the tube assembly to the round base and positioned on the counter-
weight. From underneath, insert the washer and tighten the assembly using the sup-
plied angle screw. Squeeze until it is properly locked.
•
Slide the base decorative cap down over the assembly.
•
Remove the lock nut from motor shaft. (anticlockwise).
•
Place the rear grill on the motor housing, making sure to position the housing lugs in
the guide holes of the grille.
•
Firmly tighten (clockwise) the locknut to secure the rear grille.
•
Place the fan blade on the motor shaft by placing the notches in the blade in the shaft
passing through the motor shaft.
•
Tighten with the reverse nut (counterclockwise and lock the blade securely).
•
Place the front grille and install the plastic strapping ring around the grilles to hold
them. Be sure to position the edges of the 2 grids in the 2 notches inside the strapping.
•
Tighten the grid screw to secure the ring.
•
Insert the inner tube in the main body (control panel) of the fan and fix it with the
screw at the back.
OPERATING INSTRUSTIONS
WARNING: Keep all objects at least 1 meter from the front, sides and rear of the appli-
ance.
IMPORTANT ! DO NOT COVER THIS APPLIANCE!
Place the fan on a dry, level and solid surface.
26
Publicidad
