LEGRAND C2G31011 Manual Del Usuario página 10

HDMI® HDBaseT + USB-C®, 3.5mm, and USB-B to A over Cat Extender Wall Plate
Transmitter to Box Receiver - 4K 60Hz
Upgrade
The transmitter supports upgrading FW through Micro-USB port on front panel, and the receiver supports upgrading FW through RS232 port on
rear panel. Please contact your supplier to get the latest upgrade tool "Legrand Product Firmware Updater".
Note: Do not power off the device during upgrading process.
Steps to upgrade FW:
1. Transmitter: Connect the Micro-USB port of the transmitter to the PC using a Micro-USB to USB type-A cable.
Receiver: Connect the RS232 port of the receiver to the PC using a 3-pin phoenix connector to USB type-A cable.
2. Set the DIP switch of the receiver to the position of "MCU".
3. Connect the power adapter provided to the receiver. Power on all attached devices.
Note: If the transmitter isn't connected with the receiver, it needs to be connected to another power adapter (not included in the package).
4. Open the "Legrand Product Firmware Updater" software. The interface of the software is as follows on the next page:
8
(us)
(us)