Publicidad
Idiomas disponibles
Idiomas disponibles
HDMI® HDBaseT + USB-C®, 3.5mm, and USB-B to A over Cat Extender Wall Plate
Transmitter to Box Receiver - 4K 60Hz
Features
One-way Power over HDBaseT (PoH) – transmitter can be powered by connected receiver
•
Extend 4K at 60Hz (4:2:0) up to 130ft and 1080p at 60Hz up to 230ft with Cat 6a/7 cable
•
Extend 4K at 60Hz (4:2:0) up to 115ft and 1080p at 60Hz up to 200ft with Cat 5e/6 cable
•
HDMI 1.4 with 4K at 60Hz, 4:2:0, 8bit and HDCP 2.2 compliant
•
One-way analog audio pass through from wall-plate transmitter to receiver
•
Two buttons on the panel, one for input switching and the other for turn display on/off (CEC)
•
Transmitter supports automatic switching
•
Supports USB 2.0 pass through over HDBT up to 230ft, connecting up to 4 high-power USB
•
devices to the receiver
Supports CEC switch command sent by wall-plate
•
Transmitter supports firmware upgrade and device control through Micro USB port
•
Receiver supports firmware upgrade through RS232 port
•
Mounting Bracket Installation
Note: Before installation, please ensure the unit is disconnected from the power source.
1.
Choose a suitable location for mounting bracket installation. The height of installation
should not exceed 2 meters from the ground.
2.
Position and install the mounting brackets of the receiver with the two mounting screws
provided.
3.
Mount and secure the receiver to a surface or a suitable location respectively with
mounting screws.
Package Contents
•
•
•
•
•
•
•
•
•
4
1 x Wall Plate Transmitter with screws
1 x Wall Plate Plastic Panel (2-gang US
with screws)
1 x Receiver
1 x USB-A to B Cable
1 x DC 12V Power Adapter with US Pins
2 x Mounting Bracket (with screws)
1 x Phoenix Male Connector (3.5mm, 3 Pins)
1 x Phoenix Male Connector (3.5mm, 4 Pins)
1 x Manual
(us)
(us)
Publicidad
