Publicidad
Idiomas disponibles
Idiomas disponibles
HDMI® HDBaseT + USB-C®, 3.5mm, and USB-B to A over Cat Extender Wall Plate
Transmitter to Box Receiver - 4K 60Hz
Automatic Switching
The transmitter supports automatic switching function, allowing itself to switch between two active video sources (priority: USB-C > HDMI).
Note: The automatic switching function can detect the input signal with 5V only. If the selected source in standby mode provides a continuous 5V
power output, this function will not work, i.e. the transmitter will not switch the input to other active sources. In this case, please turn off the
selected source in standby mode or remove it from the transmitter.
Device Control
Advanced users can control the transmitter via API commands through UPDATE
port on transmitter or RS232 port on receiver: connect a control PC or control
system to the UPDATE port of the transmitter (see Figure 1 on next page) or the
RS232 port of the receiver (see Figure 2 on next page). A professional RS232 serial
interface software (e.g. Serial Assist) may be needed as well.
Before sending the API command to control the transmitter, ensure the
transmitter, control PC and/or receiver are configured correctly.
Parameters
Baud Rate
Data bits
Parity
Stop bits
Flow Control
6
(us)
(us)
Value
11520 bps
8 bits
None
1 bit
None
Publicidad
