Publicidad
Idiomas disponibles
Idiomas disponibles
HDMI® HDBaseT + USB-C®, 3.5mm, and USB-B to A over Cat Extender Wall Plate
Transmitter to Box Receiver - 4K 60Hz
Product Overview
Front Panel
① ② ③ ④
F
P
D
RONT
ANEL
ESCRIPTION
On: Power is applied to the device.
1
Power LED
Off: No power is applied to the device.
Blinking: The device is working properly.
2
Status LED
Off: The device is not working properly.
On: HDCP protected content is being transmitted.
3
HDCP LED
Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
On: HDBT link is normal.
4
Link LED
Off/Blinking: No HDBT link or link error.
Pass-through (default): For controlling the transmitter for input
selection.
RS232 DIP
MCU: For MCU firmware update.
5
Switch
VS: For VS firmware update.
Note: Transmitter and receiver must be updated individually.
Receiver
⑤
Rear Panel
⑥
⑦
R
P
D
EAR
ANEL
ESCRIPTION
6
DC 12V
DC 12V power input; connect to the power adapter provided.
7
HDBT IN
Connect to the transmitter via a Cat 5e/6/6a cable.
For RS232 pass-through or firmware upgrade, and can be set through
8
RS232
DIP switch on front panel.
9
HDMI OUT
Connect to an HDMI display using an HDMI cable.
Unbalanced stereo audio output.
De-embed: For audio de-embedding from the HDMI output.
10
2x Audio Out
Pass-through: For audio pass-through from Audio In port on the
transmitter to this port.
Connect to USB devices such as keyboard, mouse, USB camera, etc.
Note: USB ports support USB 2.0 standards with a maximum of 1.4A
11
4x USB-A
for the top two ports and 0.6A on the bottom two ports. USB cameras
are recommended to be connected into one of the top two 1.4A ports.
3
Receiver
⑩
⑪
⑧
⑨
(us)
(us)
Publicidad
