Publicidad
Idiomas disponibles
Idiomas disponibles
Operating instructions
EN
Setting the indicated height
Notice: If you do not carry out the following steps in the correct order the controls revert to the standard opera-
ting mode. The controls also revert to standard mode if you wait more than five seconds before pressing the next
button.
This function can be used to change the indicated height.
For the double TG, go to the first safety stop from above and set display/measurement at 70.
For the single TG, go to the first safety stop from above and set display/measurement at 75.
S
at the same time Press
S
Hold this button down
You can now set the height with
During this process, the table-top (TM) does not move.
The position is stored and the display stops flashing. The new height is also stored if you do not press any buttons
before the display automatically stops flashing after the five second period.
Reset position alignment (E01)
If the table height (TM) has been reset or you wish to use the existing controls with another identical table (TM)
you need to first align the lowest stop position.
Press
until safety-stop. Shortly detach.
Hold down
After five seconds the tabletop (TM) will slowly start moving again until it reaches an absolute stop position. The
table stops automatically again.
Hold this button down
The table does not now move to the stop position and can be used normally again.
72 cm - 120 cm
62 cm - 127 cm
Drive
Down
Up
Drive
Display
Down
Up
and
or
and shortly detach
or with
till
goes out.
Press
Position buttons
Store button
11
Publicidad
