Toro 88715 Manual De Instrucciones página 11

Operation
Starting the Attachment
1. Ensure that the vents on the attachment, power
head, and battery are clear of any dust and
debris.
2. Align the cavity in the battery pack with the
tongue on the handle housing
3. Push the battery pack into the handle until the
battery locks into the latch.
4. To start the attachment, press the lockout button,
then squeeze the run trigger
Note:
Slide the 2-speed switch to change the
speed of the attachment.
1. Lockout button
2. 2-speed switch
(Figure 5).
Figure 5
(Figure 6).
Figure 6
3. Run trigger
Shutting Off the Cultivator
To shut off the cultivator, release the run trigger
(Figure 6). Allow at least 5 seconds for the blades
to stop moving.
Whenever you are not using the cultivator or are
transporting the cultivator to or from the work area,
remove the battery pack.
Removing the Battery Pack
from the Power Head
Press the battery latch on the machine to release the
battery pack and slide the battery pack out of the
machine (Figure
g357444
1. Battery latch
Removing the Attachment
from the Power Head
1. Ensure that the battery pack is removed from
the power head; refer to
Pack from the Power Head (page
2. Loosen the screw-handle on the shaft connector
(Figure 3).
3. Press the locking button down while pulling the
g357456
2 shafts apart
9
7).
Figure 7
Removing the Battery
(Figure 3).
g357457
9).