Descargar Imprimir esta página

Honeywell MN4CFS9 Manual Del Propietário página 17

Ocultar thumbs Ver también para MN4CFS9:

Publicidad

Idiomas disponibles

Idiomas disponibles

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
Dehumidifying Mode
Air is dehumidified as it passes through the unit without being in full cooling mode.
If room temperature is higher than 25°C (77°F), fan speed can be adjusted. Otherwise, fan speed
is preset to LOW.
Note: If the unit will be used mainly as a dehumidifier, do not connect the Exhaust Hoses.
Continuous drainage is then necessary (refer to Continuous Draining for Dehumidifier Mode).
IMPORTANT: The Dehumidifier mode is used to support moisture reduction but should not be
expected to dehumidify to the same degree as a standard dehumidifier-only appliance. The
built-in dehumidifier automatically adjusts dehumidification based on ambient room temperatures.
It is not possible to adjust to a desired humidity percentage. The front display only shows the
current AND desired temperatures. It does not show humidity levels.
Fan Mode
For air circulation without air conditioner cooling.
Heating Mode*
This unit uses Heat-Pump technology which reverses the air conditioning cooling cycle by
transferring heat from the outside into the room – this is more energy efficient than traditional
electric heaters that generate heat instead of transferring heat into the room. These properties
make this heater ideal for use in autumn or spring when outdoor temperatures are not severely
cold, or as supplemental heating in colder rooms of your home.
When heating mode is selected, the indicator light will shine. Heating is activated only when
the ambient temperature is below 25°C (77°F). In this mode, the desired temperature can be
set between 16°C- 25°C (61°F - 77°F).
Note: The Exhaust Hoses must vent outside the room when using heating mode.
IMPORTANT: The Heat pump draws moisture from the air which then condenses into the
internal water tank. The unit will pause operation when the tank is full and will restart when
the tank has been emptied. It is recommended to use the heating mode in a room with 50%
humidity or lower. Avoid operating moisture-producing products or appliances such as a
humidifier or a kettle when using the unit in heating mode.
See the "Draining Water Condensate in Heat Mode" section for more information on draining
the water tank.
*Applicable for models with Heating feature only.
EN
10

Publicidad

loading

Este manual también es adecuado para:

Mn4hfs9Mn4cfsbb9Mn4hfsbb9Mn4cfsww9Mn4hfsww9