Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
GENERAL MAINTENANCE
Condensate forms in the tank when
there is humidity in the air. Depending on
the environmental conditions, drain the
condensate daily and/or every hour. For
instructions, see Draining the tank on page 11.
The safety valve automatically releases air
when the receiver pressure exceeds the
preset maximum.
Inspect the tank annually for rust, pin holes,
or other imperfections that could cause it to
become unsafe.
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to
damage from various types of commercial
solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil,
grease, etc.
AIR COMPRESSOR
LUBRICATION
All the bearings in this tool are lubricated
with a sufficient amount of high grade
lubricant for the life of the unit under normal
operating conditions. No further lubrication
of the bearings is required.
WARNING: Do not allow brake
fluids, gasoline, petroleum
based products, etc., to come
in contact with plastic parts.
Chemicals can weaken or
destroy plastic which, may
result in serious personal
injury.
WARNING: When servicing,
use only identical Husky
replacement parts. Use of
any other parts may create
a hazard or cause product
damage.
WARNING: Always disconnect
the air compressor from the
power supply, release all
pressure, and allow it to cool
before cleaning or making
repairs on the air compressor.
12
Publicidad
