Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Information (continued)
ELECTRICAL SAFETY
(ELECTRICAL CONNECTION)
1.
This air compressor is powered by a
precision built electric motor. It should
be connected to a power supply that
is 120 volts, 60 Hz, AC only (normal
household current).
2.
Do not operate this tool on direct
current (DC). A substantial voltage
drop will cause a loss of power and
the motor will overheat. If the air
compressor does not operate when
plugged into an outlet, double check the
power supply.
ELECTRICAL SAFETY (SPEED AND WIRING)
1.
The no-load speed of the electric motor
varies by model and specification.
The motor speed is not constant and
decreases under a load or with lower
voltage. For voltage, the wiring in a
shop is as important as the motor's
horsepower rating.
2.
A line intended only for lights cannot
properly carry a power tool motor.
Wire that is heavy enough for a short
distance will be too light for a greater
distance. A line that can support one
power tool may not be able to support
two or three tools.
ELECTRICAL SAFETY
(GROUNDING INSTRUCTIONS)
1.
This product must be grounded. In
the event of an electrical short circuit,
grounding reduces the risk of electric
shock by providing an escape wire for
the electric current. This air compressor is
equipped with an electric cord having an
equipment-grounding conductor and a
grounding plug. The plug must be plugged
into a matching outlet that is properly
installed and grounded in accordance with
all local codes and ordinances.
2.
Do not modify the plug provided. If it
will not fit the outlet, have the proper
outlet installed by a qualified electrician.
3.
The conductor with insulation having
an outer surface that is green with or
without yellow stripes is the equipment
grounding conductor. If repair or
replacement of the electric cord or
plug is necessary, do not connect the
equipment grounding conductor to a
live terminal.
4.
Check with a qualified electrician or
service personnel if you do not completely
understand the grounding instructions,
or if you are in doubt as to whether the
tool is properly grounded. This product is
for use on a nominal 120-V. Only connect
the product to an outlet having the same
configuration as the plug. Do not use an
adapter with this product.
GROUNDING PIN
5
Please contact 1-888-43-HUSKY for further assistance.
120V GROUNDED OUTLET
HUSKYTOOLS.COM
Publicidad
