Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLE SHOOTING
Under the proper circumstances, your Vacuum Sealer will give you many top-notch vacuum perfor-
mances. In some instances, problems may arise. Please consult the trouble shooting menu before
calling customer support.
ERROR
E01
In order to avoid burn on the hand,
when you open the machine lid, press
"Seal" button, machine does not heat.
E02
When machine is under long time wor-
king and is overheat, the thermal over-
load will start to protect the machine.
The Vacuum Sealer won't turn on
• Ensure that the machine is properly plugged into a grounded outlet.
• Check the power cord for tears and frays. Do not use machine if power cord
is damaged.
The Vacuum Sealer doesn't pull a complete vacuum with bags
• To vacuum and seal properly, edge of bag must be across the seal bar. Make sure bag is inside the
chamber seal gasket and that there are no wrinkles in the bag along the seal bar.
• If packaging from a roll bag, make sure first seal is complete and that there
are no gaps in either seal.
• The Vacuum Sealer and vacuum bag need to be clean, dry and free of debris for the vacuum pro-
cess to be successful. Wipe surface of seal bar and inside of bag and try again.
Vacuum bag loses vacuum after being sealed
• Sharp items can puncture small holes in bags. To prevent this, cover sharp edges with paper towel
and vacuum in a new bag.
• Some fruits and vegetables can release gases (out-gassing) if not properly blanched or frozen
before packaging. Open bag. If you think food spoilage has begun, discard food. If food spoilage
has not yet begun, consume immediately. If in doubt, discard food.
The Vacuum Sealer is not vacuuming canisters properly
• The accessory hose may not be properly attached. Ensure the hose is completely inserted into the
lid of the canister and the accessory port and try again.
• Make sure the canister lid is turned to the "vacuum" setting (In Marinate Mode to "Open" setting).
• Leave adequate head space at the top of the canister.
• Make sure there isn't any damage to the canister and lid. Sometimes hairline cracks can develop
in canisters. When this happens the canister is no longer air tight and should be discarded.
• Twist knob on lid of canister to make sure it is attached securely.
26 26
CAUSE
ACTION
Close the machine lid to use the machine
again.
Shut down the machine and cut off the elec-
tricity, and allow the machine rest for about
20mins. And then re-connect and re-start the
machine.
Publicidad
