Femi Job Line TR 1030-DB Manual De Instrucciones página 44

SETTING THE BEVEL ANGLE AND THE STOP
You can tilt the head of the mitre saw from 0 up to
45°, left and right
1. To set the bevel inclination, loosen the head
bevel knob (A) Fig.11 positioned on the back
of the mitre saw.
2. To tilt the head on the left, loosen the knob (A)
then tilt the head from 0° to 45° until you get
the destre inclination, with the help of the
operating handle. Once set, tighten the knob
again.
3. To tilt the head on the right, loosen the knob
(A) and then pull the knob (B) to unlock the
unlock the inclination angle; then tilt the head
to the desired angle and from 0° to 45° with
the help of the knob (A). once set, tighten the
knob (A) again.
Note: the angle indicator must be aligned with the 45° sign on each side of the indicator, when the knob (A) is
completely loosen and the head is completely inclined on the left or on the right. If you need to adjust it,
proceed as follows
1. Loosen the knob (A) and tilt the head completely on the left.
2. Loosen the inclination stop bolt (C).
3. Adjust the inclination stop hexagonal screw (D) until the angle indicator is aligned with the inclination sign
at 45°.
4. tighten the inclination stop bolt (C).
5. Reposition the head at 0° and then pull the knob (B) to tilt the head to the other side. The angle indicator
must be aligned with the inclination sign at 45°
6. Reposition the head at 0° and make sure that the knob (B) is tighten again
WARNING ! to prevent the mitre saw from moving during this intervention:
- disconnect the feeder cable.
- block the head in the lower position and block the radial sliding movement
- Carry the machine closet o your body to prevent from injuring your back
Bend on your knees when lifting the machine
- Lift the machine from the transport handles or from the base. Do not carry it from the power
cable nor from the operating handle: you risk to damage the insulation or the electrical
connection, with serious risk to cause electric shocks or fire.
- Position the machine in not too crowded areas, where people are not supposed to circulate nor
rest. The wood chips ejected could injury people around the machine.
- Fix the machine on a stable surface, so that it can not tilt
EN
42
C
D
Fig.11