Femi Job Line TR 1030-DB Manual De Instrucciones página 46

HAZARDOUS AREAS OF THE TABLE
The working area on the table is designated as "hazardous area".
Never have your hands inside this area, during the cut
TURNING ON / OFF THE MITRE SAW
To turn on and off the machine :
1. Connect the feeder cable to the electric socket
2. Press ON button (2) Fig.1 to start the mitre saw
3. Release the ON button to stop the mitre saw
WARNING!
Do not cut short work-pieces: a too short piece won't allow you to keep your hands at a safe
distance from the disk. Never cross the hands nor position them in the cutting area.
USE OF SETTING OF THE DOUBLE LASER SYSTEM
The double laser system is controlled buy the switch (A) Fig.14 and is only active when the feeder cable is
connected to the electrical socket.
WARNING !
Do not watch directly into the laser ray generator.
1. Draw a line on your work-piece.
2. Adjust the horizontal
according to your needs
3. Before camping the work-piece, switch the
double laser on and align the line you drew with
one of the laser rays, either on the right or on
the left of the disk.
4. turn on the mitre saw on.
5. once the disk has reached the maximum speed,
lower the head to cut
To adjust the double laser system in case it is not
aligned with the blade proceed as follows :
1. Remove the laser's plastic cover.
2. Loosen the two screws (A) Fig.15 on the side of
the laser.
3. Block your work-piece on the base, turn on the
mitre saw and operate a partial cut, to mark the
two sides of the cut.
4. Rotate each laser (B) until both rays are
perfectly aligned with the two sides of the cut.
5. Once the laser is adjusted, tighten the screws
(A) without moving the lasers.
6. Reposition the laser's plastic cover.
EN
OPERATING
and bevel angles
44
Fig.14
Fig.15