Femi Job Line TR 1030-DB Manual De Instrucciones página 51

WARNING!
- Before any repair or maintenance on the machine, disconnect the feeder cable. This has to
remain disconnected every time you set or repair the machine.
- To prevent electrical shocks and fire, always use spare parts with the same characteristics
- Used, cut or damaged cables have to be immediately replaced
WOOD CHIPS
WARNING!
Use safety eyewear and vacuum cleaners to clean your mitre saw
Regularly empty the dust collection bag. Prevent the deposit of chips around and under the machine. Use a
vacuum cleaner to keep the working area clean and wholesome.
BLADE LOWER GUARD
WARNING!
Make sure the feeder cable is disconnected before cleaning the blade lower guard.
Verify regularly the correct function of the blade lower guard. Do not use the mitre saw when the blade lower
guard is damaged or missing
This protection has been mounted for your safety.
Check that the blade lower guard is not congested with chips or dust. Use a wet mop to clean it.
Note : the use of chemical solvents could damage the plastic of the protection
LASER MAINTENANCE
WARNING!
Do not watch directly into the laser ray. If you do, you risk serious injuries to your eyes. Read
and observe all safety rules about the laser.
Check that the laser is clean and wipe the dust if necessary.
1. Switch off the mitre saw and the laser. Disconnect the feeder cable.
2. Wipe the dust using a soft, clean mop
LUBRICATION
All bearings are permanently lubricated from factory; you don't need to grease them.
WARNING!
Before any repair or maintenance disconnect the feeder cable.
EN
MAINTENANCE
49