Femi Job Line TR 1030-DB Manual De Instrucciones página 49

CUTTING CURVED MATERIALS
Check the piece before cutting: if it is curved , place the piece on the base as described in the following picture:
WARNING!
If you cut the wrong way, the piece could suddenly move and cause injuries to the user
ANGLE CUTTING
1. Lift the arm to the upper position.
2. release the base rotation knob and turn the base according to the desired angle, holding the operating
handle
3. stand aligned to the new position of the head to cut.
WARNING!
Before angle cutting or bevel cutting, extend the extensions on both sides, to prevent the disk
from touching them.
BEVEL CUTTING
The head of your sliding mitre saw can be inclined
to cut any inclination, up to 45°, left or right.
Right inclination, proceed as described here below:
1. Release the inclination knob (P) Fig.17.
position the head at the desired angle, using
the inclination indicator (O).
2. Tighten the inclination knob (P).
Stand on the left side of the machine to cut left
inclination: proceed as follows:
3. Lift the head to the upper position.
4. Loosen the inclination knob (P).
5. Pull the inclination knob (Q) and position the
disk to the desired angle, using the angle
indicator (O).
6. Tighten the inclination knob (P). stand on the right of the machine to cut.
EN
P
47
O
Q
Fig.17