Abicor Binzel ABIROB W300 Manual De Instrucciones página 2

®
ABIROB W300/WH W300
EN
Proper use Torch neck of the required size and geometry complete the welding torch system ABIROB
Consumables and optional parts depending on the weld job have to be ordered separately.
For ordering information and identification numbers please consult the latest ordering catalogue.
NOTE! This product is not designed for use with high voltage wire touch sense. A shock hazard
may exist if used in this application! Please consult factory for products suitable for high voltage
wire sense applications.
Maintenance The maintenance can be carried out by the operator himself following all safety instructions and
provided that he has been trained to do so. For this purpose the torch has to be cleaned regularly
and there is a heavy build-up of spatter during every break in the welding process. Clean
interface and apply light coating of silicon-free grease to O-rings. Check parts subject to wear for
visible signs of damage and replace if necessary. Use a ABICOR BINZEL multi-purpose wrench
to secure or remove contact tip / neckliner. DO NOT USE PLIERS!
Transport The manufacturer has no influence on transportation and handling of the torch after it has left its
works. Prior to initial operation the torch has to be checked on the alignment jig and aligned, if
necessary.
Type Type of
cooling
W300 liquid
Tab. 1
EN Product-specific torch data with reference to EN 60 974-7
1Pulse-arc welding reduces the load data by up to 35%.
BEI.0304.0 • 2022-09-06
1
Rating ED
CO2 M21
A A %
330 300 100
Wire-ø Supply Flow rate
temp.
mm °C l/min
0,8 - 1,2 max. 50 min. 1,0
®
/WH.
Flow pressure
bar
1,5 - 3,5
2