Bosch Thermotechnik EMS 2 Manual De Instalación página 34

34 | Commissioning
4.3 Solar thermal system configuration
The configuration of the solar thermal system
depends on the user interface installed.
Sometimes it is only possible to operate the basic
solar thermal system for solar DHW heating with
thermal disinfection. In this case, the configuration
for the heating system, including the solar thermal
system, is described in the installation instructions
for the user interface.
Example configuration of solar thermal system 1 with functions I and K
Solar configuration completed...
Table 12
6 720 815 256 (2014/10)
ok
ok
ok
▶ Turn the selector
▶ Press the selector
▶ Press the Back key
configured up to that point.
▶ To delete a function:
– Turn the selector
function (reverse alphabetical order). is displayed.
– Press the selector
– The last function alphabetically is deleted.
▶ Solar thermal system (1) is preconfigured.
▶ Select and confirm Transfer system (I).
▶ Select and confirm Therm.dis./daily heat-up (K).
As the Therm.dis./daily heat-up (K) function is not available in
every solar system, this function is not shown in the illustration
even though it has been added. "K" is added to the name of the
solar system.
To complete the solar system configuration:
▶ Confirm the current system configuration.
to select the required function.
to confirm the selection.
ok
to go back to how the system was
until the text Delete last
.
ok
MS 100