SOMFY Roll Up 28 WF RTS II Instrucciones página 11

Roll Up 28 WF RTS II
Observations
Setting is not allowed. The
drive moves briefly 3 times
in one direction and 3 times
in the other direction. Red
LED blinks 3 times and 3
times intermittently.
Red LED blinks slowly for 3
seconds before and after
motor running.
2.4.2.Readjusting the end limits
CAUTION
Control point must be paired to the motorised product.
NOTICE
Orange LED blinks slowly until the new end limit is recorded.
2.4.2.1.Readjusting the upper end limit
1] Briefly press the Up button, to move the
motorised product to the upper end limit.
2] Press and hold the Up and Down buttons
simultaneously
product briefly moves up and down.
3] Press and hold the Up or Down button to
move the motorised product to the new
desired position.
4] To confirm the new position press and
hold the my button until the motorised
product briefly moves up and down and
green LED blinks 5 times.
©
Copyright 2021 SOMFY ACTIVITES SA. All rights reserved.
Possible causes
Maximum number of
control points reached.
Maximum/minimum value
of the setting is reached.
End limits are too close.
The drive battery is low.
Battery capacity is less than
or equal to 5%.
until the motorised
Solutions
Erase control points from
memory referring to
Erasing control points
from memory [} 13].
Perform correct setting.
Readjust the end limits
referring to Readjusting
the end limits [} 11].
Charge the battery.
1] 2]
3] 4]
EN
11