SOMFY Roll Up 28 WF RTS II Instrucciones página 18

EN
Observations
The motorised product
stops before its end limit.
NOTICE
If the motorised product still does not work, contact a drive and home
automation professional.
3.6.2.Adding/Deleting control points
A A B A B
NOTICE
Orange LED blinks slowly when adding or deleting a remote control.
3.6.2.1.Using a control point that has been previously programmed to
the motorised product
1] Press and hold the PROG. button (A) on
the programmed control point until the
motorised product briefly moves up and
down.
ð Green LED blinks 5 times then orange
LED blinks slowly.
2] Briefly press the PROG. button (B) on the
control point to add or delete.
g Green LED blinks 5 times.
18
Possible causes
Thermal protection of the
drive is on (Red LED blinks
slowly).
The drive has detected an
obstacle (solid Red LED).
A B
Copyright
1]
2]
©
2021 SOMFY ACTIVITES SA. All rights reserved.
Roll Up 28 WF RTS II
Solutions
Wait for the drive to cool
down (Red LED will stop
blinking when drive is ready
to use).
Move the motorised
product in the other
direction.
2 s
A
PROG.
0.5 s
B
PROG.