SOMFY Roll Up 28 WF RTS II Instrucciones página 9

Roll Up 28 WF RTS II
times. The lower end limit is now
memorized. The motorised product
moves up and stops at its upper end limit.
5] To confirm and complete end limits
programming: Press and hold the my
button until the motorised product briefly
moves up and down. The end limits are
now programmed.
2.3.4.Recording "Pairing" the control point
After recording the end limits:
▪ Briefly press the control point PROG
button.
◦ The motorised product briefly moves up
and down to confirm pairing.
→ The control point is recorded "paired" to the
motorised product and green LED blinks 5 times.
2.4.Tips and advice on installation
2.4.1.Questions about the product?
Observations
The motorised product
does not operate.
©
Copyright 2021 SOMFY ACTIVITES SA. All rights reserved.
Possible causes
The drive battery is low and
requires charge. Red LED
blinks 5 times when any
button of a paired control
point is pressed.
The control point battery is
low. LED doesn't light
when any button of a
paired control point is
pressed.
0.5 s
PROG.
Solutions
Charge the battery.
Check the battery and
replace it as required.
EN
9