Publicidad
Idiomas disponibles
Idiomas disponibles
Roll Up 28 WF RTS II
2.4.4.Modifying the wheel rotation direction
1] Using the Up or Down button on the
control point, move the motorised
product away from the end limits.
2] Press and hold the Up and Down buttons
simultaneously
product briefly moves up and down and
orange LED starts to blink slowly.
3] Press the Up, my and Down buttons
simultaneously, until the motorised
product briefly moves up and down, wheel
rotation is reversed and green LED blinks 5
times.
2.4.5.Erasing control points from memory
To delete all the programmed control points,
press and hold the drive head programming
button until the motorised product briefly moves
up and down twice.
→ All programmed control points are deleted and
orange LED blinks 5 times every 10 seconds.
2.4.6.Erasing the memory of the drive (factory default)
To reset the drive, press and hold the drive head
programming button until the motorised product
briefly moves up and down 3 times.
➔ All the settings are erased. Green LED blinks 5
times then orange LED is fixed on.
3.USE AND MAINTENANCE
NOTICE
This drive does not require any maintenance operations.
3.1.Mode selection: Roller or Tilting Mode
The drives are designed to work in 2 modes: Tilting mode or Roller mode.
©
Copyright
2021 SOMFY ACTIVITES SA. All rights reserved.
until
the
motorised
1]
2]
3]
EN
2x
3x
13
Publicidad
