Specifications
Input power
Peak-to-peak ripple
Current consumption
Normal operation
Alarm
Mounting height
Target speed range
Microwave frequency
Maximum power output
Maximum microwave output power at
1 m (continuously)
Alarm output
Tamper output
Alarm time
Walk test
Operating temperature
Relative humidity
Dimensions (W x H x D)
Weight
Mirror type
DD100PI
DD105(C)
Number of zones
DD100PI
DD105(C)
Viewing angle
IP/IK rating (with sealed cable entry)
Dual loop
DD100PI
DD105(C)
Pet immunity
Usage restrictions
VdS installation note
In VdS installations, a VdS sticker must seal the detector cover
and base (see Figure 6). VdS stickers can be ordered under
the part number Aritech VS200 (50 stickers per sheet). Only
one DD100-D series detector without an alarm memory may
be connected to a zone.
Regulatory information
Manufacturer
PLACED ON THE MARKET BY:
Carrier Fire & Security Americas Corporation Inc.
13995 Pasteur Blvd
Palm Beach Gardens, FL 33418, USA
AUTHORIZED EU REPRESENTATIVE:
Carrier Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
4 / 28
9 to 15 VDC (12 V nom.)
2 V (at 12 VDC)
11.5 mA nom.
15 mA max.
1.8 m to 3.0 m
0.2 m/s to 3.0 m/s
2400.0 to 2483.5 MHz
1 mW
0.005 µW/cm²
80 mA at 30 VDC
100 mA at 30 VDC
3 s
0 VDC to terminal 8
−10 to +55°C
30 to 95%
61 x 123 x 58 mm
150 g
5C90D47
7C90D47
5 at 10.0 m
7 at 12.0 m
86°
IP30 IK02
No
Yes
DD100PI
Models DD100PI and DD105
may not be used in the United
Kingdom
Product warnings
THESE PRODUCTS ARE INTENDED FOR
and disclaimers
SALE TO AND INSTALLATION BY QUALIFIED
PROFESSIONALS. CARRIER FIRE &
SECURITY CANNOT PROVIDE ANY
ASSURANCE THAT ANY PERSON OR ENTITY
BUYING ITS PRODUCTS, INCLUDING ANY
"AUTHORIZED DEALER" OR "AUTHORIZED
RESELLER", IS PROPERLY TRAINED OR
EXPERIENCED TO CORRECTLY INSTALL
FIRE AND SECURITY RELATED PRODUCTS.
For more information on warranty disclaimers and
product safety information, please check
https://firesecurityproducts.com/policy/product-
warning/ or scan the QR code.
Certification
DD100PI: EN 50131-2-4:2008
Tested and certified by Applica Test &
Certification
Carrier Fire & Security hereby declares that this
device is in compliance with the applicable
requirements and provisions of all applicable rules
and regulations, including but not limited to the
Directive 2014/53/EU. For more information see:
firesecurityproducts.com
REACH
Product may contain substances that are also
Candidate List substances in a concentration
above 0.1% w/w, per the most recently published
Candidate List found at ECHA Web site.
Safe use information can be found at
https://firesecurityproducts.com/en/content/intrusi
on-intro
2012/19/EU (WEEE directive): Products marked
with this symbol cannot be disposed of as
unsorted municipal waste in the European Union.
For proper recycling, return this product to your
local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated
collection points. For more information see:
recyclethis.info
Product
Please consult the following weblink to retrieve
documentation
the electronic version of the product
documentation.
This link will guide you to the EMEA regional
contact page. On this page you can request your
login to the secured web portal where all manuals
are stored.
https://firesecurityproducts.com/en/contact
Contact information
firesecurityproducts.com or www.aritech.com
DA: Installationsvejledning
Beskrivelse
Detektoren er en kombi detekter, hvor PIR delen benytter
mikrobølge som verificering. Det er derfor vigtigt at placere
detektoren således, at en person forventes at bevægelse sig
vinkelret på og/eller diagonalt i dækningsområdet (figur 7–8).
Kombidetektoreren giver høj driftstabilitet og reducerer falske
alarmer. Man bør dog stadig søge at undgå kendte fejlkilder,
så som f.eks.:
P/N 145919999-4 (ML) • REV N • ISS 06APR21