Publicidad
Idiomas disponibles
Idiomas disponibles
ABICAR 1200 PRO 42V
Navigating the configuration menu
You can navigate as follows in the configuration menu:
Tab. 4
Required actions
Rotate F1 to the right or to the left.
Rotate F2 to the right or to the left.
Keep F2 pressed and rotate to the right
or to the left.
Press F2.
Saving the JOB.
Set all parameters.
1
Tab. 5 on page EN-22
Rotate F1 to change to the "Save setup" parameter.
2
Rotate F2 to select the desired JOB number.
3
Press F2.
4
The JOB will be saved and the message "Done" will be shown briefly on the display.
Changing the JOB
Rotate F1 to change to the "Load setup" parameter.
1
Rotate F2 to select the desired JOB number.
2
Press F2.
3
The configurations saved in the JOB will be loaded and the message "Done" will be shown briefly
on the display.
The configuration can now be adjusted and re-saved.
Menu navigation
6 Putting into operation
Function
Select the next or previous parameter.
Tab. 5 Welding parameters overview on
page EN-22
Set the value of the selected parameter.
The value will be applied and does not have to be
confirmed.
Set the units position or the decimal place of the
selected parameter.
The value will be applied and does not have to be
confirmed.
Confirm and save the selection.
(Only for "Save setup" and "Load setup".)
EN - 21
Publicidad
