Dri-Eaz Revolution LGR 111995 Manual Del Propietário página 18

Idiomas disponibles

Owner's Manual

Philips screwdriver

10 mm wrench

6 mm hex bit and T45 bit

¼ in. nut driver

Cleaning cloths

HEPA vacuum cleaner with soft brush nozzle and crevice nozzle.

Recommended

Cordless drill, small knife, small-jaw pliers, coil cleaning solution, rotomolded

housing cleaning solution.

BEFORE EACH USE

Inspect the electrical cord for damage. Look for fraying, cuts, etc. Do not use the

unit if you find any damage. Contact your local authorized distributor for service.

Inspect filter. Replace if accumulation of dust and debris is visible.

NOTICE: Replace used filters only with a new Dri-Eaz 4-PRO filter part no.

#102312 (F583) (24-pack). Other filter types do not provide adequate filtration or

airflow. Each filter is individually wrapped to protect filtration effectiveness. Remove

the wrapper before installing the filter into the dehumidifier.

MONTHLY

Inspect coils. Clean when dust accumulation is visible. In normal use, dust can

accumulate and can restrict airflow, reducing performance and causing the unit to

overheat. Use a vacuum cleaner with a brush tool and a soft cloth to remove any

debris. Take care not to damage any interior components.

To maintain appearance, wipe interior and exterior surfaces with a damp cloth. For

deep cleaning and a lasting, protective shine, use an automotive interior cleaner.

AS NEEDED

Clean pump check valve and basin. Remove grills and cover as shown in Fig. B.

Remove screws from pump base and lift out pump. Wipe out pump basin with a

damp cloth. Inspect the pump base for build-up of debris and clean if needed.

Unthread barbed fitting with check valve and rinse fitting and check valve with clean

water. Reinstall check valve into barbed fitting and install the barbed fitting into pump.

Do not overtighten. Reinstall pump on base. Reinstall cover and grills.

Clean coils. With the cover removed, inspect both coils. If excessive dust and debris is

present, vacuum thoroughly and/or clean with coil cleaner.

Revolution LGR Owner's Manual