Publicidad
Idiomas disponibles
Idiomas disponibles
The bed fails to
respond to the
wireless remote
control
Nothing works
Nothing works
Wrong motor
engages
Nothing works
Nothing works
Bed is not
responding to the
wireless remote
control
Bed is not
responding to the
wireless remote
control
The operating box is
not able to pick up
the signal of the
handset. The signal
may fail to reach the
operating box if the
handset is at a
substantial distance.
Unidentified
malfunction.
Cause
The plug is not in the
socket.
Wrongly installed.
No main power
supply.
Operating box defect.
Remote control and
control unit are not
linked.
The child lock on the
remote control is
turned on.
Check if the
operating box has
been fixed properly.
Search
Check if the current
is switched on at the
mains power supply,
or whether another
appliance has caused
a short circuit.
Place the operating
box in the designated
spot.
Remove the plug
from the wall socket
and wait 10 seconds
before replacing
and/or remove the
batteries from the
remote control for
one minute.
Solution
Put the plug into the
socket.
Install according to
fitting chart.
Throw earth leakage
circuit breaker if
necessary.
Replace.
To link the remote
control and the
control unit, see
paragraph 4.5.
To turn off the child
lock on the remote
control, see
paragraph 4.3.
EN
10
Publicidad
