Publicidad
Idiomas disponibles
Idiomas disponibles
(104)
Haojue DR160/DR160S 99011H2J024H000 V04 ES+EN+FR 2020-1-17
help of the stand.
2. Remove the engine oil dipstick 1.
3. Place a drain pan below the engine. Dismantle the
drain plug 2 and its washer to drain the original
engine oil.
4. After draining all the engine oil, install the drain plug
2 and its washer.
5. Fill 1100 milliliter of new engine oil into the engine via
the oil filling port of the dipstick.
6. Install engine oil the dipstick again 1.
7. Start the engine and have it run for several minutes.
8. Stop the engine and inspect the engine oil with
the dipstick several minutes later.
level should be between the UPPER LEVEL and the
LOWER LEVEL.
BCAUTION
EN
Use
the
engine
"Instructions for use of fuel and engine oil".
BCAUTION
Carefully inspect whether the engine parts that
have been dismantled and installed again suffer
any oil leakage.
(104)
Haojue DR160/DR160S 99011H2J024H000 V04 ES+EN+FR 2020-1-17
The engine oil
oil
recommended
in
the
Engine oil strainer
BWARNING
Due to that the cover of the right crankcase must be
removed before removing the strainer, whether the
strainer needs to be replaced should be determined
by the professional technical personnel of the
dealer.
CLUTCH
Method to inspect the clutch cable gap 4: remove the
rubber bush 1 along the clutch cable, operate the clutch
handle and make sure there is a gap of 3–5mm before
there is an apparent resistance. If the gap is insufficient,
adjust it with the method below.
1. Remove the rubber bush 1 along the clutch cable,
loosen the nut 2.
2. Turn the adjusting screw 3 clockwise till the end.
3. Loosen the lock nut 5, adjust the nut 6 along
the front-back direction, operate the clutch lever and
adjust the clutch cable gap 4 to be 3–5mm.
4. Do fine adjustment through the adjusting screw 3.
39
Publicidad
