GET 2ND INJ. KIT Guia De Instalacion página 3

5. GET Second Injector kit works only with GET ECUs which are
"second injector ready" (with the specific "INJ 2" connector).
The GET 2nd Injector Kit can be supplied:
Included in GET Pro Factory Kit: GET ECU is plug&play and
it is ready to operate after the second injector is installed.
The ECU comes with two pre-installed maps:
- Map 1: activate only the OEM injector
- Map 2: activate the OEM injector and GET 2nd injector
As accessory to a compatible GET ECU installed previously:
in this case, before installing the 2nd Injector Kit it is
necessary to install the specifically developed power map
on the ECU. Download it for free from www.athena.eu on
the specific product page and install it using GET Maya
programming software (sold separately). Otherwise, ask
for assistance from your GET dealership.
B. PRODUCT LAYOUT
1x M5X8 mm screw
GET Fuel Rail
Wiring of
the 2nd
injector
2x O-Rings
3x self-locking nuts
and 3x washers
1x M4x25mm
screw
GET fuel line
1x M5X18mm screw
3
Three-way
fitting
2nd GET
injector
6x hose
clamps
2nd injector
support bracket
2x M4x14mm
screws
EN