GET 2ND INJ. KIT Guia De Instalacion página 7

WE
BECAUSE THIS HOLE WILL BE USED TO
POSITION THE SECOND INJECTOR.
WARNING: DO NOT USE DRILL BITS, USE ONLY
MILL BITS. REMOVE ANY RESIDUE REMAINING
FROM THE MILLING PROCESS: RESIDUE CAN
DAMAGE THE ENGINE OR COMPROMISE ITS
PERFORMANCE.
12. Remove the intake duct again from inside the air filter case.
FUEL HOSES
1. Locate the OEM fuel hose and remove it. Check your
motorcycle's workshop manual to see where to find it. Remove
the OEM fuel rail from the fuel hose.
2. Stretch the OEM fuel hose to eliminate the bends already
present, as shown in the figure. Shorten it by 50 mm / 1.96" on
the fuel rail side of the OEM injector.
To the fuel pump
OEM
3. Cut the GET fuel hose supplied in the kit into two sections: one
50 mm / 1.96" (A) and the other 100 mm / 3.93" (B).
RECOMMEND MAXIMUM
50 mm / 1.96"
7
PRECISION
EN