Kärcher FC 7 Cordless Premium Manual De Instrucciones página 17

bacteria can cause an unpleasant odor
in the device.
After finishing work, place the device in
the cleaning station and start the rins-
ing process.
Only clean the floor head in the clean-
ing station with the automatic rinsing
process and not by separately pouring
water into the station. Make sure the
waste water tank is in place.
Do not clean the device or the top or
bottom of the floor head under running
water or under a shower spray, other-
wise water may enter.
Note
As long as the display "MAX" (red)
lights up, and the waste water tank has
not been emptied, the rinsing process
cannot be started.
Note
The LED lighting on the floor head is
switched off during the rinsing process.
1. Press the ON / OFF switch.
The device switches off.
2. Empty and reinsert the waste water
tank (see chapter Inserting the
waste water tank).
3. Place the device with the empty
waste water tank in the cleaning sta-
tion.
4. Fill the fresh water tank with 200 ml
fresh water without detergent or
care agents (see chapter Filling the
fresh water tank).
Note
It is not necessary to add detergents
during the rinsing process.
5. Hold the ON/OFF switch and the
cleaning level adjustment button si-
multaneously pressed for
3 seconds.
A signal tone sounds.
6. The display indicators light up re-
peatedly from top to bottom.
The rinsing process begins and
takes about 2 minutes.
English 17