ATTENTION!
Before using the ladder, read carefully the general norms
(from page 36 to page 44).
5.5 3-ELEMENT MULTI-PURPOSE LADDER
MAX 150 Kg
EN 131.1
D.L. 81
EN 131.2
ASSEMBLING THE STABILIZER BAR
1) Remove one of the feet from the
stabilizer bar by loosening the
screw, as shown in Figure 1.
2) Place the stabilizer bar in
the slots corresponding to
the anchoring holes. (2)
3) Tighten the plug on the bar
using the screw previously
removed. (3)
4) Install the 2 aluminum blocks at
the base of the element, and
make sure the stabilizer bar is
also secured. (4)
lf you wish to lean the ladder
against the wall, follow what is
said below:
Lay the ladder on the floor.
1) Extend the 3rd element along the
2nd as much as needed and
block it by means of the hook on
the corresponding rung.
2) At this point, follow the instruction
for the 2-element multi-purpose
ladder, leaned against the
wall (starting from point "2").
3) Anchor the ladder on top with a
belt or another device, in order to
avoid any sliding or side skidding
risk.
lf you wish to use the ladder as a
shears ladder:
At this point, follow the instruction for
the 2-element multi-purpose
ladder, used as a shears ladder (star-
ting from point "2").
1) Anchor the ladder on top with a
belt or another devi ce, in order to
avoid any sliding or side skidding
risk.
Next >
OPERATING AND SAFETY INSTRUCTION MANUAL . 50
AVAILABLE ARTICLES
ST.3N Series
ST200/3N - ST250/3N
3 elements
ST300/3N - ST350/3N
S3.EM Series
S3250/EM - S3300/EM
3 elements
S3350/EM - S3400/EM
S3450/EM
1
2
3
4
RISK OF FALLING. DO
NOT CLIMB UP THE THIRD
SECTION. USE IT ONLY
AS A SUPPORT FOR YOUR
HANDS.
ATTENTION!
Before using the ladder, read carefully the general norms
(from page 36 to page 44).
If you wish to use the ladder as a
shears ladder on surfaces at
different levels:
At this point, follow the instruction for
the 2-element multi-purpose
ladder, used as a shears ladder (star-
ting from point "2").
ATTENTION!
Ladders set up to be used on
heights of over 8 m must be fitted
with a beam to reduce the
inflection length.
Use accessory ART.P4.
5.6 SCALA TELESCOPICA MULTIUSO IN ALLUMINIO
MAX 150 Kg
D.L. 81
EN 131.4
AVAILABLE ITEMS
Teles
Max. Capacity
T4B-T5B-T6B
T4B-T5B 150kg
D.L. 81
T6B 100kg
Teles TT
TT55-TT66
EN 131
Teles
T4-T5
D.L. 81
Teles
STA-T3
T4A-T5A
MANDATORY
EN 131
Super Teles
STA-T3
T4S-T5S
MANDATORY
EN 131
Super Teles
STA-T3
T6S
MANDATORY
D.L. 81
max 100kg
Super Teles
STATELES /
T6SA
RTELES
EN 131
MANDATORY
ADDITIONAL BASE
Standard on models:
EXPANDERS
T4A-T5A-Super Teles
Next >
51. OPERATING AND SAFETY INSTRUCTION MANUAL
RISK OF FALLING. DO
NOT CLIMB UP THE THIRD
SECTION. USE IT ONLY
AS A SUPPORT FOR YOUR
HANDS.
03
RTELES
Kit assembly
33
65