Descargar Imprimir esta página

Noaton 12132WWB MAIA Manual De Uso página 34

Ocultar thumbs Ver también para 12132WWB MAIA:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
BALANCING THE CEILING FAN
If there is any wobble after installing the ceiling fan, check that the screws that secure the joint,
mounting plate, hinge, blade bracket, and blades are secure. If any of the above listed parts wobble,
resecure them. If it continues to wobble, try the following options:
1. Swap the blades among each other.
2. Adjust using a balancing kit:
PRECAUTIONS
Warning
To prevent fire and electric shock, it is prohibited to install and use an electrical switch that is not
equipped with this ceiling fan.
Maintenance
1. It is recommended to check the connecting parts of the fan, such as the mounting plate
and fan blades, at least once a year to ensure that their connection is still safe and reliable.
2. Regularly clean the outer surface of the fan. Use a soft brush or cloth to remove dust
from the surface. When removing oil or laminate, wipe it with a slightly damp cloth. Do
not rinse directly with water.
3. The motor bearing is already lubricated, do not add lubricating oil to the ceiling fan
motor. To avoid scratching the surface.
Warranty
The warranty covers serious problems that may occur, but not minor deviations such as slight noise
produced by the appliance, as every electrical appliance produces a certain amount of noise.
Remove the balancing kit, use the balancing clamp to remove one of the fan
blades and clamp the balancing clamp to the edge of the fan blade.
Turn on the fan and see if the ceiling fan oscillation has decreased. If it does
not improve, try a different fan blade. Experiment with all fan blades in turn
to find the blade with the weakest wobble.
Clamp the balancing clamp on the fan blade with the weakest wobble, slide
it in or out on the edge of the fan blade, turn on the ceiling fan to find the
best position of the balancing clamp to balance the wobble.
Take the balancing sticker and stick the balancing sticker on the centre of the
blade at the location of the balancing clamp. If the load is still insufficient, attach
another sticker.
34

Publicidad

loading